VONROC GT501DC Traducción Del Manual Original página 11

4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on the
charger (5) will lighten up and show the charger
status.
The charger has 2 LED indicators (5) which indicate
the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from
the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Mounting the Protection guard (Fig. B1)
• Fit the protection guard (10) onto the trimmer
head housing.
• Secure the guard using the screw (11) delivered.
Mounting the guardrail (Fig. B2)
• Squeeze the ends of the guardrail (12) together
and slide into the holes of the trimmer head
housing
• The guardrail can be set in different protection
distances. To adjust the rail, simply press or pull
the rail.
Mounting the front handle (Fig. D1)
• Place the handle (8) on the holder mounted on
the upper shaft.
• Fit the bolt in the hexagon hole and mount the
knob (9) onto the bolt.
WWW.VONROC.COM
Adjusting the front handle (Fig. D2)
• Unscrew the knob (9) slightly and press or pull
the front handle (8) in to desirable position. This
can either be down or upwards and rotatable
around upper shaft.
Charger status
No power
Mounting of the side wheel (Fig. E)
• Slide side wheel (13) over the side wheel holder
Standby mode:
(14).
- No battery is
inserted or,
Mounting the wire spool (Fig. F1)
- Battery inserted
but charging has
finished
Battery charging in
• Place the spring (17) into the spool housing
progress
(18). Make sure the wider side of the spring is
placed on the trimmer head.
• Place the spool reel (16) over the spring (17).
Make sure the wires are passed through the
holes inside the housing (18). (Fig. F2)
• Cover the spool reel with the spool cover (15)
and fasten it by turning the cover tightly.
Replacing the spool (Fig. F1)
• Remove the spool cover (15).
• Take out the spool reel (16) but leave the spring
(17) inside.
• Take the new spool reel (GT801AA) and place
it over the spring (17). Make sure the wires are
passed through the holes inside the housing
(18). (Fig. F2)
• Cover the new spool reel with the spool cover
(15) and fasten it by turning the cover tightly.
4. OPERATION
Using the tap and go system (Fig. G)
• When the wire is too short, switch the machine
on and press the tip of the spool reel (19) on
the ground (make sure this is done on a hard
surface).
• This will release the wire in order to get longer.
• The wire will be cut on the correct length auto-
matically by the blade mounted in the protecti-
on guard (10).
When using the machine sideways always
use the sidewheel.
Before replacing the spool clean the
machine from any dirt.
EN
11