Installation Instructions - Honeywell Home TCPA1BS Instrucciones De Instalación

CR123 LITHIUM 3V
1
Wireless Panic Button
TCPA1BS

Installation instructions

General Information
3a
The TCPA1BS is a wireless keyfob that may be worn around the neck, on a wrist band or as an apparel clip that
may also be mounted to a desk. Pressing the keyfob button for at least 1 second and releasing it, sends a
signal to the panel.
Registration and Configuration
1.
4
1
1 2
*https://international.mytotalconnectcomfort.com
6 7
11 17
https://tc20e.total-connect.eu
WEB
21 1
AA Ni-MH HR6 1.2V
CR123 LITHIUM 3V
2. To start registration, press the keyfob button for 5 seconds.
Battery Replacement (see figure on first page)
The TCPA1BS is powered by a long-life Lithium battery that may be replaced when a low battery is eventually
indicated by the control unit.
1. Remove 4 screws and lift off cover.
2. Using a small flat-blade screwdriver remove old battery.
3. Insert new battery by placing new battery under the gold tab and then pressing down. Ensure the positive (+)
side of battery is face up after installation.
4. Align cover and attach with 4 screws.
NOTE: When replacing the battery, wait a minimum of 10 seconds prior to installing the new battery.
NOTE: Although water-resistant, please do not immerse in water at a depth below 10cm for more than 1
hour.
17
Specifications:
Unit
LED
Battery
Operating Temperature
CAUTION: risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to battery manufacturer instructions and applicable regulations.
HR6 1.2V
2.5min
1.8m
2a
2
1
https://international.mytotalconnectcomfort.com
https://international.mytotalconnectcomfort.com
WEB
WEB
PORTAL*
3 4 5
8 9 10
2mins
0 5
10 1
15
12
https://tc20e.total-connect.eu
Sucre Box + (SUEPACK-EG)
>1.5m
2 3 4
2
Dimensions: 9 mm diameter
WEB
lights when unit transmits
3-Volt CR2032 Lithium
-10°C to +55°
30cm
2.1m - 2.7m
(2.3m)
1
3b
x2
5
1
2
2.5min
2
evohome hub GPRS
getconnected.honeywell.com
English
6
2mins
0
5
10
15