Troubleshooting
Problem
Possible Cause
Display will not
1.
turn on
held down
long enough.
2. Battery needs to
be charged.
Buttons do not
Low battery or
work
camera frozen
Display not
1. Power supply not
charging
correctly inserted
in charger port.
2. Power supply
not connected
to power.
Error Message
1. Power to camera/
displayed: See
handle is off.
Manual for
2. Batteries low in
Troubleshooting
camera/handle.
or No Video
3. Wand not properly
connected
to handle.
Image too dark or
1. LEDs not set to
bright
proper brightness
Follow all safety protocols when diagnosing issues with
the tool.
Possible Solution
not
1. Hold
for
>3 seconds.
2. Attach power
supply to
charge battery.
1. Straighten a paper
clip.
2. Insert the end of
the paper clip into
the RESET hole
(Figure
42
A
1. Check connection
of adapter to
charging port.
2. Check that power
supply is properly
plugged into
outlet.
3. Check outlet
for power.
1. Check that power
switch is on.
2. Check the charge
state of the
AA batteries.
3. Check connection
of the wand to
the handle.
1. Adjust LED
brightness
with switch.
2-YEAR WARRANTY
Stanley warrants its electronic measuring tools against
deficiencies in materials and/or workmanship for 2 years from
date of purchase.
Deficient products will be repaired or replaced, at
Stanley's option, if sent together with proof of purchase to:
Stanley Black & Decker
210 Bath Road
Slough, Berkshire SL1 3YD
UK
This Warranty does not cover deficiencies caused by accidental
damage, wear and tear, use other than in accordance with the
manufacturer's instructions or repair or alteration of this product
).
not authorised by Stanley.
Repair or replacement under this Warranty does not affect the
expiry date of the Warranty. To the extent permitted by law,
Stanley shall not be liable under this Warranty for indirect or
consequential loss resulting from deficiencies in this product.
This Warranty may not be varied without the authorisation of
Stanley. This Warranty does not affect the statutory rights of
consumer purchasers of this product. This Warranty shall be
governed by and construed in accordance with the laws of the
country sold where in and Stanley and the purchaser each
irrevocably agrees to submit to the exclusive jurisdiction of the
courts of that country over any claim or matter arising under or
in connection with this Warranty.
Calibration and care are not covered by warranty.
NOTE:
The customer is responsible for the correct use and care of the
instrument.
Subject to change without notice
DISPOSAL OF THIS ARTICLE
Dear Customer,
If you at some point intend to dispose of this
article, then please keep in mind that many of its
components consist of valuable materials, which can
be recycled.
Please do not discharge it in the garbage bin, but
check with your local council for recycling facilities
in your area.
GB
Li-ion
13