Stanley FATMAX FMHT0-77422 Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
• Always insert batteries correctly with regard to polarity
GB
(+ and –), as marked on the battery and the equipment.
• Do not short battery terminals.
• Do not charge disposable batteries.
• Remove dead batteries immediately and dispose of per
local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries when the device is not in use.
Battery Installation (Figure B)
Open the battery cover (10) by gently pressing in at the
locations (23) shown in Figure B. Connect the 9V battery (24)
(6F22 or equivalent), ensuring polarity. Close battery door.
Battery Replacement (Figure B)
When the symbol
should be replaced.
Wait until the thermometer turns off automatically. Open the
battery cover (10) by gently pressing in at the locations (23)
shown in Figure B. Replace battery with 9V battery (24) (6F22
or equivalent), ensuring polarity is correct. Close battery door.
Components
THERMOMETER (Figure A)
1
Button
2
Button
3
Button
4 MODE Button
5 Built-in 1/4-20 Nut
6 Handle
7 LCD Display
8 IR Sensor
9 Measurement Trigger
10 Battery Cover
11 Laser Pointer
NOTE: The thermometer can be attached to a suitable support
with a 1/4-20 bolt using the thermometer's built in 1/4-20 nut (5).
6
appears, the battery is low and
LCD INSTRUCTION (Figure A)
12 MAIN DISPLAY shows the present reading or last reading.
13 DATA HOLD indicator appears when the reading on the
main display is locked.
14 MEASUREMENT INDICATOR appears and flashes when
the thermometer is taking measurements.
15 EMISSIVITY DISPLAY shows the present emissivity setting
value. TIP: The symbol means Emissivity.
16 BACKLIGHT INDICATOR appears when the backlight
function is active.
17 TEMPERATURE UNIT applies to both the main display and
the bottom display.
18 SYMBOLS used to indicate the kind of value being
displayed on the bottom display. EXAMPLE: If the symbol
" MAX " appears, the value on the bottom display is the
maximum value.
19 BOTTOM DISPLAY used to display maximum (MAX),
minimum (MIN), difference (DIF), average (AVG), high alarm
value (HAL) and low alarm value (LAL).
20
is the high alarm icon, and
alarm icon.
21 LOW BATTERY INDICATOR
immediately when the low battery indicator appears.
22 LASER FUNCTION INDICATOR appears when the laser
function is enabled. When this indicator appears, the laser
pointer will emit a laser beam when the trigger is pulled.
BUTTON INSTRUCTIONS (Figure A)
1
Button
Used to change temperature units from Celsius to
Fahrenheit value(s).
When setting emissivity ( ), high alarm value (HAL),
or low alarm value (LAL), press this
increase the value to be set
Button
2
Press this button to turn on or off the backlight.
To enable or disable the laser function, press
button while pulling and holding the trigger. When the
laser function is enabled, the symbol
is low
: Replace the battery
button to
appears.

Publicidad

Tabla de contenido
loading

Tabla de contenido