General Instructions; Safety Instructions - Denios PRO 2 Manual De Instrucciones

English

General Instructions

No modifications or alterations can be made to the product without authorisation from the manufacturer, in the
event of this, the guarantee will be invalidated.
National standards and safety regulations must be observed.

Safety instructions

Before the product is used, it is to be checked for correct functioning. Should any defects appear, it must not be
used!
Only use for the intended purpose!
Do not use on uneven ground
The bearing capacity given must not be exceeded!
Use and intended purpose
General purpose trolleys and Service trolleys
goods.
Assembly
First of all attach the push handle (5) to the upper floor (4). To do this use the washers (7) and screws (6).
Then attach the 4 wheels (8) together with the washers (9) to the lower floor (1).
Now put 4 pipes (2) on the corners of the lower floor (1). If you have a model with 3 levels, put the middle floor on
the pipes (3) and 4 more pipes (2) on the corners of the middle floor.
Then put the upper floor with the push handles on the pipes (2).
For secure support it is necessary to secure the connections (floors and support pipes) by tapping them lightly
with a rubber hammer.
Please do not use a metal hammer under any circumstances.
Specifications
See type label.
Maintenance and servicing
Check the rollers for ease of movement and if necessary grease with commercial grease.
Check at regular intervals for any damage. In case of damage, that could influence the carrying capacity, the
product must not be further used!
KST-Allzweck-, Servicewagen
180037, 180038, 180042
are intended for the in-works transporting and storing of warehouse
Seite 4 von 6 Seiten Ausgabe 10/2008