General Instructions; Safety Instructions - Denios FH Manual De Instrucciones

English

General Instructions

No modifications or alterations can be made to the product without authorisation from the manufacturer, in the
event of this, the guarantee will be invalidated.
National standards and safety regulations must be observed.

Safety instructions

Before the product is used, it is to be checked for correct functioning. Should any defects appear, it must not be
used!
- The bearing capacity given must not be exceeded!
Use and intended purpose
Material stands are aids for storing material at a suitable height.
The operational temperature range is between -10°C and + 40°C.
Specifications
See type label.
Operation
Loading
When loading the table, care is to be taken that the load is evenly distributed over the table surface.
Brake function
The 4 swivel castors of the material stand are equipped with adjustable brakes.
- To brake press the locking device down.
-
To release the brake lift the locking device up.
Adjusting the height of the table
The brake must be applied before any adjustment of the height of the table.
The height of the material stand FH can also be adjusted when it is laden.
Raising:
Activate the lifting pedal several times until the table has reached the desired height.
The table cannot be raised further when it has reached its maximum height even if the pedal is further activated.
The hydraulic cylinder now holds the table at the desired height.
Lowering:
If you put your foot on the lowering lever the table goes down
Tilting the table
The table can be tilted at 5 different angles between 0° and 40°. The material stand must not be laden when it
is tilted. Remove the safety bracket on the swivelling axis of the table and tilt the platform into the desired position.
Then fix the table again with the safety bracket.
Materialständer
154085
Seite 5 von 12 Seiten
on
Brake
Release
brake
off
Ausgabe 10/2007