Denios PRO-S Manual De Instrucciones página 4

English
General Instructions
No modifications or alterations can be made to the product without authorisation from the manufacturer, in the
event of this, the guarantee will be invalidated. National standards and safety regulations must be observed.
Safety instructions
Before the product is used, it is to be checked for correct functioning. Should any defects appear, it must not be
used!
Only use for the intended purpose!
Do not use on uneven ground
The bearing capacity given must not be exceeded!
Use and intended purpose
General purpose trolleys POR-S are intended for the in-works transporting and storing of warehouse goods.
Assembly
First of all attach the push handle (5) to the upper floor (4). To do this use the washers (7) and screws (6).
Then attach the 4 wheels (8) together with the washers (9) to the lower floor (1).
Now put 4 pipes (2) on the corners of the lower floor (1). If you have a model with 3 levels, put the middle floor on
the pipes (3) and 4 more pipes (2) on the corners of the middle floor.
Then put the upper floor with the push handles on the pipes (2).
Then put 4 pipes (2) on the corners of the lower floor (1) and insert two side parts (10) and a back part (11)
between the supporting pipes. Then lay the middle floor (3) on the pipes and walls and mount on it 4 more pipes
(2), 2 side parts (10) and 1 back part (11).
Then install the upper floor with the push handles as the upper level.
For secure support it is necessary to secure the connections (floors and support pipes) by tapping them lightly
with a rubber hammer.
Please do not use a metal hammer under any circumstances.
Specifications
Safe working load: 240 kg
Maintenance and servicing
Check the rollers for ease of movement and if necessary grease with commercial grease.
Check at regular intervals for any damage. In case of damage, that could influence the carrying capacity, the
product must not be further used!
KST-Allzweckwagen
180041
Seite 4 von 6 Seiten Ausgabe 05/2010