Denios HW / HWD Manual De Instrucciones página 16

6.1.4 Measuring a total sum of weights
Adding several gross weights together (weights under 20 kg are not included)
Press the →0← key (deletes tare weight)
1)
2) Pick up load, raise forks
3) Press the Σ ..key
4) Lower forks, remove load
5) Repeat steps 2 to 4 with all individual loads
6) Press the Σ ..key for a long time (3 sec)
7) Press the Σ ..key once for a long time (3 sec) and
then immediately press once again briefly
Adding several net weights together (weights under 20 kg are not included)
Press the →0← key (deletes tare weight)
1)
2) Pick up empty pallet, raise forks
Press the →0← key
3)
4) Lower forks
5) Pick up loaded pallet, raise forks
6) Press the Σ ..key
7) Lower forks, remove load
8) Repeat steps 5 to 7 with all individual loads
9)
Press the Σ ..key for a long time (3 sec)
10) Press the Σ
then immediately press once again briefly
6.1.5 Changing between kilograms and pounds
You can change between metric and imperial weight readings by pressing briefly on the
6.1.6 Switching the scales off
.Ф..
Press the key for at least 2 seconds. "Off" will appear on the display while you hold down the key. The
display will then turn off.
Gabelhubwagen HW/HWD
128380;164485
..key once for a long time (3 sec) and
Seite 16 von 35 Seiten
- Display = 0,0
- Display = Gross weight
- Weight recorded and printed out
(on HWD model)
- Display = 0,0
- Total of weights added together is shown
- Weighing procedure completed and printed out
(on HWD)
- Display = 0,0
- Display = Weight of pallet (e. g. 40 kg)
- Display = 0
- Display = -40kg
- Display = Net weight
- Weight is recorded and printed out (on HWD)
- Display = 0,0
- Total of weights added together is shown
- Weighing procedure completed and printed out
(on HWD)
.Ф..
key.
Ausgabe 09/2011