Publicidad
Idiomas disponibles
Idiomas disponibles
Package Contents
• Color-Choice Optical Mouse
• Instruction Manual
• 2 AA Batteries
• Nano Receiver
System Requirements
• Windows
XP, Vista, Windows 7
®
• Mac 10.1 or higher
• Available USB Port
Connecting your mouse
Connect your new mouse (nano receiver) to the USB port on your computer. Locate
the nano receiver in the battery compartment on the bottom of the mouse. Once your
computer has automatically identified your mouse move the mouse to ensure there is a
good connection.
If your mouse does not work properly, check that the
nano receiver is pushed all the way into the USB port.
If the mouse still is not responding please replace the
batteries. If after following these steps your mouse still
does not work, please contact Jasco product support
at www.jascoproducts.com or call 1-800-654-8483.
Changing the color clips
1. Locate the groove at the rear of the
mouse where the color clip meets
the base. Stick your thumbnail in the
groove and pry the color clip up and
off of the mouse.
2. Take the new color clip of
your choice and position the
front of it over the mouse,
matching the plastic posts
on the underside of the clip
to the holes on either side of
the scroll wheel.
Thumbnail groove
Post holes
Metal
plates
3. Press the color clip down gently until you
hear the magnetic pins click into place. It is
securely on the mouse now. Enjoy your new
mouse color!
Posts
Magnetic
pins
Publicidad
