JCM Technologies BASELEC500 Manual De Usuario página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Free System Operation
MOTION GROUPS
This equipment can work with the group identification of the system FREE. Receivers can be configured with a group (from 0 to 7)
that allows management of up to 28 doors independently.
GROUPS CONFIGURATION
After the receiver has been totally reset, it will be configured with the group of the first radio-programmed transmitter by enabling the
hands free mode.
On powering the receiver, the led R1 will flash the same number of times as the group number with which it is configured.
Maintenance
USE OF THE CONTROL PANEL-RECEIVER
This equipment is intended to be used for remote control systems in automatic doors.
Their use is not guaranteed for directly activating any other equipment different to that specified.
The manufacturer reserves the right to modify equipment specifications without prior notice.
IMPORTANT ANNEX
Disconnect the power supply before handing the unit.
In compliance with the European Directive low-voltage electrical equipment, we hereby inform users of the following requirements:
· For units which are permanently connected, an easily accessible circuit-breaker device must be built into the wiring system.
· This unit must always be installed in a vertical position and firmly fixed to the structure of the building.
· This unit must only be handled by a specialised installer, by his maintenance staff or by a duly trained operator.
· The instruction manual for this unit must always remain in the possession of the user.
· Terminals of maximum section 3,8mm2 must be used for the power supply connections.
· Use time delayed fuses.
· The two working frequencies does not interfere each other.
EU DECLARATION OF CONFORMITY
The manufacturer JCM TECHNOLOGIES, S.A., declares that the product BASELEC500 complies with the relevant fundamental
requirements of the RED Directive 2014/53/EU and of the RoHS Directive 2011/65/EU.
See website
www.jcm-tech.com/en/declarations
JCM TECHNOLOGIES, SA • BISBE MORGADES, 46 BAIXOS - 08500 VIC (BARCELONA) SPAIN
Page 8/8
UM_3200348_BASELEC500_2ID_Rev01

Publicidad

Tabla de contenido
loading

Productos relacionados para JCM Technologies BASELEC500

Tabla de contenido