Bradley S19-399 Guia De Inicio Rapido

Installation Instructions
Waste Cart S19-399 for Onsite
NOTE: The On-Site
filled. Make sure the petcock is "closed" before filling the tank.
1. Attach the casters to the bottom of the cart with the hardware provided as shown in Figure 1.
• The rigid casters are attached to the front of the cart and the total lock swivel casters are
attached to the back of the cart. Line up the casters with the studs on the bottom of the cart
and then secure in place.
2. Attach the drain tube to the back of the On-Site
in the top of the waste cart (use whichever hole is closest to the back of the eyewash unit).
Lower the eyewash unit onto the cart tray as you feed the tube into the hole.
3. After the On-Site
instructions outlined on the front of the eyewash unit.
Waste Cart Tray
Insert the Drain Tube
(269-1676) (not shown)
into one of the holes
located in the tray
Total Lock
Swivel Caster
(269-1682)
(qty. 2)
Petcock
Drain the fluid from
the cart into an
appropriate waste
receptacle or drain
215-1428 Rev. A; EN 02-534
Page 1 of 3
Unit is positioned on the cart (facing either eyewash sign) before the tank is
®
eyewash unit is properly positioned, fill the eyewash tank following the
®
Rigid Caster
(269-1681)
(qty. 2)
Eyewash
®
tank and feed the tube into one of the holes
®
P.O. Box 309, Menomonee Falls, WI 53052-0309
TEL. 1-800-BRADLEY
http://www.bradleycorp.com
Figure 1
Waste Cart
(131-086)
5/8" Washer
(142-002BJ)
(qty. 4 per caster)
5/8"-18 x 3/4"
Hex Hd Cap Screw
(160-207)
(qty. 4 per caster)
FAX 262-251-5817