Sophos XGS 116 Manual Del Usuario página 6

ENGLISH
2. Mount and Connect the Appliance
Mount the antennas (for wireless models only)
Connect the provided antennas to the connectors on the back of your appliance and align them in a
vertical position.
Connect the ports to the internal and external networks
1. Connect the port 1/LAN via a switch to the internal network. For this purpose, use the RJ45 Ethernet
cable provided. Note that your Administration PC must also be connected to this network.
2. Connect Port 2/WAN to the external network. The connection to the WAN depends on the type of
Internet access.
XGS appliances are shipped with the following default settings:
Ethernet Port
1/LAN
2/WAN
Admin Console Username
admin
Default Gateway
DHCP
Mount the appliance to the rack
If you want to mount the device within a rack please use the optionally available rackmount kit for this
device.
4
IP Address
172.16.16.16/255.255.255.0
DHCP
Admin Console Password
admin
DNS
DHCP
Zone
LAN
WAN
CLI Console Password
admin
DHCP Service
Enabled
Quick Start Guide XGS 116(w)/126(w)/136(w)