Additional Precautions - Drive RTL12061 Manual De Instrucciones

assembly instructions
Rotating
Seat
Receptacle
Leg
Height
Adjustment
Leg
1. Remove contents from carton.
2. Assemble legs by inserting the height adjustment legs
into the white rubber tip. Make sure to put the tips
on the end without the brass push pin. Repeat for 3
other legs.
3. Insert the height adjustment leg into larger leg
receptacle by depressing the brass push pin. Repeat
for 3 other legs.
4. Lay seat upside-down on a flat surface. Insert each
leg into the seat depressing the brass push pin on the
leg receptacle and inserting into the bottom of the
seat. A click can be heard when the leg is securely in
place. Repeat for 3 other legs.
5. Turn the bath bench right-side-up. Attach the soap
tray by placing it between the legs and inserting the
cross braces into the receptacles on the white leg
collars.
adjusting leg height
1. Before use, adjust height of each leg to your specific
needs, making sure all legs are at the same height.
When desired height is reached, lock legs into place
by aligning buttons into proper holes.
2. To be sure legs are locked into place, push down on
or pull up on the legs.
1. To rotate seat, pull up on handle until seat is free
Seat
Handle
Note: Built into the seat frame are 4 locking positions
which will secure the seat in place to allow the user to
safely stand up from or sit down on the seat. Make sure
Storage
the seat is in one of the locked positions before standing
Tray
or sitting.
Rubber
Tip
The rotating seat and the two ball bearing rings that
move the seat can be replaced if necessary. To remove
seat and ball bearing rings, turn the lock knob (RTL12061-
KNOB) under the seat clockwise until removed. Remove
seat (RTL12061-SEAT ) and ball bearing rings (RTL12061-
RING). Replace seat, ball bearing rings and lock knob.
Tighten until secure.
1. Inspect all parts for shipping damage before assembly.
2. Make certain that the height adjusting snap buttons
3. Check the rubber tips on the leg extensions for rips,
4. All four leg extensions with rubber tips MUST touch
5. DO NOT stand on chair.
NOTE: To maintain the beauty of the original finish, clean
with mild soap and rinse with warm water. Wipe bath seat
dry after each use.
rotating seat
of one of the 4 locked positions and rotate to desired
position. Seat can rotate in both directions.
replacing seat

additional precautions

If there is shipping damage - DO NOT USE. Contact
dealer/carrier for further instructions.
fully protrude through the same respective hole
of each leg extension. This will ensure that the leg
extensions are securely locked in position and an
even height is achieved.
wear or if they are missing. Immediately replace any
or all if any of these imperfections exist.
the floor simultaneously at all times.