Controls; Other Features - GE ADEW20 Manual Del Proprietário

Controls

Clean the Filter
indicator light
indicator light
Controls
NOTE: When the bucket is full or removed, the controls
cannot be set.
1. Power Pad
2. Filter Timer
indicator light will glow to remind you to clean the filter.
Remove the filter and clean it.
and Cleaning section.
3. Humidity Set Control Pads
set the unit for continuous operation, press the – pad
NOTE:
settings if attached to a hose to drain or until the bucket
is full.
For drier air, press the – pad and set to a lower
For damper air, press the + pad and set to a higher

Other Features

Empty Light
Glows when the bucket is ready to be emptied, or when the
bucket is removed or not replaced in the proper position.
Alarm
If the bucket is full or missing for more than 3 minutes, an
empty and replace the bucket.
Auto Shut Off
when the bucket is full, or when the bucket is removed
Continuous
Operation on
indicator light
Nonstop
On Filter
-
Filter
Power
Timer
Hold 3 Sec To Rest
High, Medium
delay off
indicator light
indicator lights
+
Delay
Fan
Off
When you first use the dehumidifier, set the humidity
dehumidifier to achieve the humidity level. If you still
have damper air than desired, set the humidity level
dehumidification.
4. Display
5. Fan Speed Pad
Controls the fan speed.
speed.
removal. When the humidity has been reduced and
6. Delay Off
While the dehumidifier is in operation, press this pad to
removed.
Auto Defrost
When frost builds up on the evaporator coils, the
compressor will cycle off and the fan will continue to run
until the frost disappears.
Power Outage
In the case of a power outage or interruption, the unit will
automatically restart, in the settings last used, after the
power is restored.
Bucket Full light indicates
bucket needs to be
emptied or is not in place
in the unit
Empty
49-5000397 Rev. 0