Power Management
The hob is equipped with a power limitation. If you reach the maximum power it will be impossible to
increase the power on the different cooking zones and a beep signal will sound. This limitation is set
at 2900W by the factory but it is possible to change it to 2900 W, 5600 W or 7400 W.
Power limitation configuration
Before beginning the procedure:
• Make sure there is no more pot on the hob
• Disconnect the appliance from the grid by removing the fuse or turning the circuit breaker off.
• Reconnect the table to the grid
• Start the procedure within 2 minutes after reconnecting the hob to the grid
• Make sure all cooking zones are off.
Procedure:
To set the power limitation, you must:
1) Press simultaneously the two key of the
bottom zones during 3 seconds. A beep
will sound and the current power is
displayed.
2) To set the power limitation use the [
changes, don't touch any key for 60 seconds.
3) To save the new power limitation, re-press the two key of the bottom zones during 3 seconds.
Once the new limitation registered, a beep will sound.
] and [
]. To exit the procedure without saving your
11