Do not operate without water. To prevent
*
such cases, the kettle is outfitted with a boil-dry
protection device that will shut off the appliance.
To use the kettle again, disconnect it and let it cool
for 15 minutes, then refill it and switch it on again.
The water level must be between the MIN and MAX
*
water level gauge markings. Overfilling the kettle
may cause the water to spill when boiling and cause
burns.
Make sure to close the lid tightly before use
*
to prevent scalding by the emitted steam.
Be careful never to open the kettle lid when
*
the water is still hot. The steam emission may
cause burns!
While the kettle is on, do not touch any surfaces
*
other than the side handle. They get very hot and
may cause burns.
Do not move the appliance while in use.
*
Caution: the appliance remains hot after use.
*
Always allow the appliance to cool before storing
or cleaning it.
Wait for 15 to 20 seconds before starting a new
*
boiling cycle to allow the kettle to cool.
Keep the appliance or the cord away from any
*
sources of heat, hot objects or open flame.
Disconnect from the outlet when the appliance is
*
not heating, during cleaning or before opening the
lid of the appliance.
To remove the anti-scale filter, lift the kettle off its
*
base and allow it to cool. Never remove the filter
when the appliance contains hot water.
Do not pull on the power cord or on the appliance
*
itself to disconnect it.
Never place your appliance on a hot surface.
*
Do not let the appliance operate unattended.
*
To avoid hazards, do not use the appliance after
*
dropping it and if it shows visible signs of damage.
If your appliance has been damaged, stop using it and
*
contact the Customer Service of
If your appliance has been damaged, do not attempt
*
to repair it yourself. Any unauthorised modifications
or repairs of the appliance will void the warranty.
To ensure your safety, use only
*
accessories and spare parts that are suitable for
your appliance.
44
44
.