Pond Boss 52360 Manual De Instrucciones página 5

Step 3. Place the bioballs in the
bottom of the tank.
Step 4. Place the fine (blue) filter
pad inside the tank. Then place the
coarse (black) filter pad inside the
tank.
Step 5. Place the tubing adapter on
the upper hole of the tank and use
a gasket for it to be sealed tightly
when fastened.
Hand-tighten the locking ring
inside the tank to secure the tubing
adapter in place.
Step 6. Turn over the filter cover
and locate the groove along the
outside edge of the raise surface.
Inspect the o-ring to find the flat
edge. One side will have a curve
and the other side will be flat. Insert
the flat side of the o-ring down as
you place into the groove.
Step 7. Turn the cover with the
o-ring back over and place in the
opening in the filter.
Step 8. Screw the lid onto the top of
the tank. Make sure the lid is secure
or the filter will leak.
Step 9. Unplug your pump from an
electrical source before connecting
tubing. Connect tubing from the
outlet of the pump to the inlet of
the filter (upper hole). Return water
to the pond by connecting tubing
to the outlet of the filter and to the
inlet of a water feature or return to
the pond. You can reconnect your
pump into a properly grounded
electrical outlet at this time.
Note: Pump and tubing are not
included.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO STORE: 1-888-755-6750
3
7
4
5
6
8
9
3