AllPondSolutions PLED-310 Manual De Instrucciones página 3

Thank you for purchasing the All Pond Solutions PLED Aquarium
Light. You will find in this manual details of how to set up and install your
light correctly.
SAFETY
Important! To protect against injury, basic safety precautions should
be observed, including the following:
Read and follow all safety advice and notices on this appliance before
·
using. Failure to do so may result in loss of fish life and/or damage to this
appliance.
IMPORTANT – To avoid possible electric shock, care must be taken since
·
water is employed in the use of aquarium equipment. Disconnect from
the mains electricity supply when handling the unit, or when attempting
installation or maintenance of any kind. Do not attempt to modify this unit
in any way and only use the recommended parts for replacement.
The unit should not be plugged in if there is water on parts of the
·
appliance.
If the unit or any part of it falls into the water DO NOT put your hands into
·
the tank. First unplug the unit before removing it.
All connections must be earthed.
·
Do not use this unit if it has a damaged cord or plug, if it is malfunctioning
·
or it is dropped or damaged in any manner
Do not carry or pull the unit by its electrical cable.
·
When switched on, do not look directly at the LED lights.
·
Do not yank cord to pull plug from outlet. Grasp the plug and pull to
·
disconnect. Always unplug an appliance from an outlet when not in use.
Do not install or store the appliance where it will be exposed to weather
·
or temperatures below freezing. FOR INDOOR HOUSEHOLD USE ONLY.
DO NOT IMMERSE IN WATER
Make sure the appliance is mounted correctly and securely positioned on
·
the aquarium before operating the light.
Care should be taken to arrange the cord so that it will not be tripped
·
over or pulled.
Make sure the appliance is mounted correctly and securely positioned on
·
the aquarium before operating the light.