Care & Maintenance; List Of Parts; Replacement Parts - Cosatto NITTY GRITTY WAFFLE Manual Del Usuario

care & maintenance
Marks may be removed with a damp cloth.
•
Occasional use of mild detergent will maintain the good looks of your highchair.
•
Regularly check all fastenings to ensure that they are properly tightened.
•
Do not submerge wooden tray in water, wipe clean only. Neither the wooden tray nor plastic
•
outer tray are dishwasher safe.
For wash care instruction for the seat liners please refer to the wash care label location on each
•
liner.

list of parts

Your highchair is supplied in one carton and contains:
Back cushion
(A)
Seat cushion
(B)
Outer tray
(C)
Inner tray
(D)
Rear leg assembly
(E)
Right side frame
(F)
Left side frame
(G)
Upper back rest
(H)
Please note that some of the fixings listed above are pre-fitted to the highchair wooden components for
security. Unfasten the fixings prior to assembly.
The remaining fixings - 2 x short bolts (T), 4 x shake-proof bolts (U), 4 x nuts (V), and 2 x small screws (W)
are located in the fixing pack along with an Allen key (X).

replacement parts

The replacement parts shown below are available for your product. In the event that you require any of
these parts:
For UK & Ireland customer, the replacement parts can be ordered through our website:
http://www.cosatto.com/service-centre/spares
If you require any further assistance, please contact us at cuddle@cosatto.com
For customer outside UK & Ireland, contact information for your local distributor can be found on:
http://www.cosatto.com/stockists.
Back cushion
•
Seat cushion
•
Outer tray
•
Inner tray
•
Rear leg assembly
•
Right side frame
•
Left side frame
•
Upper backrest
•
Lower backrest
•
Lower back rest
(I)
Waist retain bar
(J)
Seat base
(K)
Metal support bar
(L)
Footrest
(M)
Wooden support bar
(N)
5 point harness
(O)
Crotch strap
(P)
Waist retain bar
•
Seat base
•
Metal support bar
•
Footrest
•
Wooden support bar
•
5 point harness
•
Crotch strap
•
Hinge covers (Set)
•
Fixing pack
•
Hinge covers (A & B)
(Q)
Barrel nut x8
(R)
Long bolt x6
(S)
Short bolt x6
(T)
Shake-proof bolt x4
(U)
Nut x4
(V)
Small screw x2
(W)
Allen key
(X)