Ceado E6X Manual De Uso Y Mantenimiento página 20

20
Clean the motor housing and the tray
with a cloth dampened with water or alcohol
or with a spray neutral solution.
Wipe with a dry cloth.
Never put the appliance under running
water and never immerse in water.
Once the hopper has been removed it can
be washed with lukewarm water and neutral
soap, then rinse it and dry well.
Cleaning the doser unit requires great
care because inside it there is an
electromechanical device which could get
damaged.
- Use a brush or a paintbrush (Fig. 8) to clean
the most hidden areas inside the unit and a
dry cloth for the other surfaces.
MAINTENANCE
Maintenance must be carried out exclusively by qualified technical personnel.
Care for the mechanical and electrical parts of the appliance is indispensable in order to guarantee
their safety and efficiency. If any parts need replaced, authentic spare parts must always be used.
ASSEMBLY OF THE TELESCOPIC PRESS (OPTIONAL) AND OF ITS
LONG SUPPORT FORK
Before performing any assembly operations, unplug the appliance.
To assembly the telescopic press (optional) and its long support fork, proceed as follows:
Remove the Ceado sticker from the doser (1, Fig. 9) and remove the support fork, undoing the
1
retaining screws (2, Fig. 9). Keep these screws in a safe place.
Choose the suitable press diameter (53, 54,5 or 57,5 mm) for the filter-holder of your coffee
2
machine and fix it to the rod of the telescopic press (1, Fig. 10).
Position the long support fork supplied with the telescopic press and fasten it using the same
3
retaining screws of the short fork removed previously (2, Fig. 10).
Position the telescopic press and fasten it with the screws provided (3, Fig. 10).
4
Correctly tighten the retaining screws of both the telescopic press (1, Fig. 11) and the new fork
5
(2, Fig. 11).
GB
Fig. 8