Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & OPERATION
1. Remove light box from box.
2. Plug the cord into an electrical outlet.
3. Flip the rocker switch to the on position located on the right-hand side of the light box. It will take a couple of
seconds for the lamp to warm up.
4. Remove both peg bars from the box. Place desired peg bar in recessed area on rotating disc. Place paper over
pegs and begin drawing.
MAINTENANCE
CLEANING: Clean the plastic and stainless steel surfaces with a soft cloth and nonabrasive cleaner. Do not apply cleaner
directly onto light box as it may seep inside the unit.
LAMP REPLACEMENT:
Caution: Be certain that the light box is unplugged and the power is off before
replacing the lamp.
To Remove Lamp: (Figure 1)
1. Pry open the top edge of the plexiglass mounting platform by placing a screwdriver
in the small hole located at the back left corner of the light box. Press the tip of the
screwdriver up to release the plexiglass. Grab the loosened corner of the
plexiglass and lift out of remaining corners to remove.
2. Grasp lamp with both hands and turn it approximately a ¼ turn towards you until
the tension releases in each socket. Lift and remove the used lamp.
To Reinstall Lamp: (Figure 2)
1. Insert both ends of the lamp with the prongs vertical into the
lamp socket.
2. Turn the lamp approximately ¼ turn until you feel it lock into place.
3. Snap plexiglass surface back into place by inserting one side fi rst
and then the other. Using slight pressure, press on all four sides to
ensure that it is locked in place.
LUBRICATING ROTATING SURFACE: Apply a light coating of Armor All (or similar
silicone vinyl protectant) around the edge of the rotating surface with a soft cloth.
Wipe off excess.
OTHER PRODUCTS
Artograph manufactures a full-line of opaque art projectors, light boxes, spray booths and Open Studio furniture. Please
visit us at www.artograph.com for more product information.
PLUG INTO YOUR CREATIVITY AT WWW.ARTOGRAPH.COM
Figure 1
Figure 2
Publicidad
