senya SYWB-AP002 Manual Del Usuario página 29

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
7. Application signal icon
Press and hold the On/off button
ready state for connected, and the application signal icon
 Please complete the connection steps within 3 minutes, otherwise the device will quit the
connection state.
 The application signal icon will display after the connection is completed
8. Filter replace icon
When the filter replace icon turns red, it's time to replace a new filter.
1) Turn off the device and unplug the power cord.
2) Turn the device upside down and remove the bottom cover. You can place a soft cloth under
the control panel to avoid scratches.
3) Remove the current filter, and replace it with a new one, then put back the bottom cover.
4) Turn on the device, press the On/off button
for 6 seconds to reset the program.
5) The Filter replace icon
Note:
 The new filter life is about 3800 hours.
 If you need to buy new filter , please contact our after-sales service at service-
client@senya.fr
III.3.2 Use the Senya Smart™ Application operation device
Before control the device by Application, make sure the device is power on and connected
successfully.
for 5 seconds to hear a "beep" sound, the device enters the
flashes 3 times to indicate the completion of the reset.
Editio
Current PM2.5 index
Current air
Filter lifespan
On/Off
29
flashes.
and the Fan speed button
at the same time

Publicidad

Tabla de contenido
loading

Tabla de contenido