Preparation
1.
Remove cover and lid When using in first time
Remove the buffer material between the cover
and body part.
2.
Make sure ultrasonic vibration plate cover is
installed
※ Mist would not generate if the ultrasonic vibration plate cover
has not been installed.
※ Place the product on a stable surface
3.
《Using in USB port of computer》
Insert the supplied USB cable to USB port of
computer or mobile battery and connect to DC
jack on a stable surface.
※
Mist may not generate normally or power may be off
depending on different computer.
Do not connect with USB hub
·
USB hub cannot ensure stable power supply, the
product may not operate normally.
·
Place the product on a stable surface which is
Caution
not near the connected computer.
Computer failure may be caused if it exposes to mist.
·
Connect USB cable before adding water.
·
Use USB port with 1.0A output.
How to use
5
cover
lid
ultrasonic vibration
plate cover
USB plug
DC jack
DC plug