Unpacking The System; Placement Options; Speaker Connections - Boston Classic CS 2310 Manual Del Propietário

E
N
G
L

Unpacking the System

I
S Carefully unpack the system. If there is any sign of damage from transit, report it immediately to your dealer and/or delivery
H
service. Keep the shipping carton and packing materials for future use.

Placement Options

The CS 2310 speakers can easily be placed upon a tabletop or wall-mounted. The center channel and satellite speakers are
designed to easily mount on the wall using the keyhole slot(s) on the back of the speaker. When mounting the speakers to
the wall, use the supplied rubber bumpers.
The keyhole mounting option is similar to hanging a picture frame on a wall. Install a
#8 screw (not included) into the sheetrock, making sure to go into a stud, and hang
the speaker onto the screw head. If a stud is not available, a sheetrock anchor should
be used to support the weight of the speaker. It is advisable to connect the speaker
wire prior to wall-mounting.
NOTE: Because there are so many different kinds of surfaces on which the speakers
could be mounted. There is no one type of fastener that we could supply that would
work in all the possible situations. So taking into account the surface the speaker is
being mounted on, acquire the appropriate type of fasteners. If you're not sure what
type of fastener to use, take the mounting bracket to a friendly hardware store, tell
them about the wall you're mounting the speaker on, and ask them to recommend
an appropriate fastener. Keep in mind the weight of the speaker.

Speaker Connections

After your speakers are properly placed, you are ready to wire your system. First, turn off all system
power. Use the speaker wire included with the system to make your connections. Please see the
illustration for guidance connecting the wires to the satellites and center channel.
Important!
To ensure the best performance observe polarities when making speaker connections, as shown in
the illustration. Connect each + terminal on the back of the amplifier or receiver to the respective +
(red) terminal on each speaker. Connect the – (black) terminals in the same way. If the connections
are not made correctly it can cause poor bass response and imaging. Also, to avoid short circuits
that may damage your equipment be careful not to let any of the bare wires touch each other.
Subwoofer Connections
NOTE: Power is always supplied to the subwoofer electronics unless it is unplugged or switched to the off position using the
power switch located on the rear panel. The auto-on circuitry only activates or deactivates the power amplifier. Make sure
your subwoofer and receiver are unplugged when making the connection.
Power: When plugging your subwoofer in be sure to use a wall outlet, or dedicated electrical outlet. Some receivers will
provide a switched outlet. Do not use this. These on board electrical outlets do not offer the amount of current or proper
isolation required by a power amplifier, such as the one in your amplifier.
4
Keyhole Mount
Rubber
Bumper
Be sure to maintain
proper + and – polarity
at all speaker wire
connections.