Jones Stephens L65001 Guia De Inicio Rapido

L65001
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
Tools Needed for Installation:
• Adjustable End Wrench
• Phillips Screwdriver
Contents:
2 – Hexagonal legs
2 – Pointed leg tips
2 – Leg end nuts
2 – 4" Leg extension screws
2 – Lock nuts
2 – Escutcheons with set screws
2 – Lugs for cast iron sinks
2 – Rubber hat washers for vitreous china sinks
Note: Before beginning the installation, look beneath the sink to determine the
type of sink and correct installation procedure. If the sink has holes in the corners
sink has a hollow bottom with molded tips in the corners, follow the instructions
for cast iron sinks.
Vitreous China Sink Instructions
to sink distance. Be sure to cut the leg squarely.
2. Remove the protective covering from the hexagonal leg.
3. Place the escutcheon over the leg, bell end up and insert the leg end nut into the top of the leg.
4. Thread the 4" leg extension screw halfway into the leg end nut.
5. Screw the lock nut onto the leg extension screw down to the leg end nut.
6. Place the rubber hat washer on the end of the leg extension screw.
7. Insert the rubber hat washer into the hole in the bottom of the sink and position the leg
vertically.
8. Rotate the leg to extend the leg extension screw to the point where the sink is level and its
weight is supported by the rubber hat washer.
9. Tighten the lock nut against the top of the leg end nut.
set screw and turn the leg so the set screw is toward the back of the sink.
11. Repeat steps 2 through 10 for the other leg.
Note: The lugs are not required for this installation and may be discarded.
TRADITIONAL LAVATORY LEGS
POINTED
LEG TIP
HAT WASHER
EXTENSION
ESCUTCHEON
English
RUBBER
SCREW
LOCK NUT
SET
SCREW
LEG
1