CEBEK R-24 Manual De Instrucciones

It allows a PWM regulation from 0 to 100% of the load connected to the circuit.
It incorporates a led indicator and minimum output setting.
POWER SUPPLY :
The power supply voltage cannot be less than 8 VDC. nor higher than 30 V.DC.
We recommend using a stabilized power supply or a battery for the correct operation of the circuit. The supply
voltage must be equal to the voltage of the device to be regulated.
For example, if you want to regulate a 24V DC motor, you will need to supply the 24V DC circuit.
Connect the power supply to the "Input" terminal respecting the polarity of ±.
Install a switch and a fuse for the protection of the circuit and your own safety, according to CE standard.
Before activating the switch, make the rest of the circuit connections.
OUTPUT CONNECTION AND MINIMUM ADJUSTMENT :
want to regulate. Remember that it cannot consume more than 4 A. To adjust the minimum output level, act on the
"Min Level" potentiometer.
POTENTIOMETER CONNECTION : To regulate the output level, connect a 10K ohm potentiometer to the
"EXT. . "
POT
Il permet une régulation PWM de 0 à 100% de la charge connectée au circuit.
Il incorpore un indicateur LED et un réglage de sortie minimum.
ALIMENTATION ÉLECTRIQUE :
30 V.DC.
DC REGULATOR DC - 4 A.
RÉGULATEUR DC - 4 A.
REGULADOR DE CC - 4 A.
REGULADOR DE CC - 4 A.
La tension d'alimentation ne peut pas être inférieure à 8 VCC. ni supérieur à
www.cebek.com -
R-24
Technical characteristics
Supply Voltage : 8-30 V. D.C.
Consumption : 35 to 125 mA
Maximum load : 4 A.
Frequency PWM : 100hZ
External Potentiometer : 10 K ohms
Measures : 87 x 72 x 36 mm.
Weight : 65,5 gr
Din Rail : C-7566
Connect the "Output" terminal to the device you
sat@fadisel.com