COLUMBUS ELECTRIC ET9 Serie Manual De Instrucciones

LINE VOLTAGE THERMOSTAT – ET9 SERIES
DESCRIPTION
The Columbus Electric wall mounted line voltage thermostat is
suitable for direct connection with any resistance heating ele-
ments and unit heaters. This thermostat has a snap action switch
operated by a bimetal actuator and is available in single pole,
double pole with positive off, two stage heat. Cooling only and
heat or cool models. Other options include a built in thermome-
ter and/or 6 inch wire leads.
INSTALLATION INSTRUCTIONS
Application: A vertical wall box is used for mounting thermostat
4 to 5 feet above the fl oor on an inside wall where the thermostat
will be subject to average room temperature. It should be away
from concealed warm or cold water pipes, warm or cold air ducts,
draft s from hallways or stairways.
WARNING Disconnect power from source.
1.
AVERTISSEMENT
2. Remove cover from old thermostat.
3. Remove old thermostat by removing two screws.
4. Disconnect supply wires from old thermostat.
5. New installation: remove cover by gently pulling away from
thermostat.
6. Make connection of supply lead(s) (red) and load lead(s)
(black) using an approved connector (wire nut, crimp cap, or
etc.).
7. Connect the ground wire to the terminal marked "GRD" or
8. All wiring must conform to application code, ordinanances
and regulations in such matters as wire size, type of insulation
and enclosure.
9. Dress wires into wall box and secure your new thermostat to
the wall box with the screws provided.
10. Reinstall cover, select desired temperature and restore power.
LINE
LOAD
SPST
HEATING OR COOLING
LINE
NO INTERNAL
CONNECTION
IN SWITCH
LOAD
YELLOW
SPST WITH ANTICIPATION
HEATING
P/N: 8426
COLUMBUS ELECTRIC
a division of TPI Corporation
Débrancher l'alimentation de la source.
WIRING DIAGRAMS
LINE
LINE
HEATING AND COOLING
ELECTRICAL RATING
22 A Resistive @ 125/250/277 Vac.
3/4 HP @ 125 Vac.
1-1/2 HP @ 250/277 Vac.
TEMPERATURE RANGE
SETTING RANGE......50°F TO 90°F
HEATING OR COOLING. 50°F TO 90°F
COOL ONLY.. 90°F TO 50°F
75°F HI STOP....35°F TO 75°F
If this product is used to replace a device containing mercury,
the purchaser or consumer must ensure that the mercury is
properly managed to comply with state or federal regulations.
Th e mercury must not become part of solid waste or waste
water. Additional guidance may be obtained from the manufac-
turer of the product being removed, or by calling
Columbus Electric Manufacturing Company Materials Manager.
COOL LOAD COOL LOAD
HEAT LOAD HEAT LOAD
SPDT
HEATING OR COOLING
LOAD 1
LOAD 2
TWO STAGE
SPECIFICATIONS
DIFFERENTIAL
HEAT APPROXIMATELY:............. 2°F
COOLING APPROXIMATELY:..... 4°F
HEAT ANTICIPATOR MODELS:. 1/2°F
DIMENSIONS
4-3/4" ....... HEIGHT
2-7/8" ....... WIDE
2-7/8" ....... DEPTH
WARNING
AVERTISSEMENT
1-800-251-7828
LINE
LOAD
DPST
OPTIONAL ANTICIPATOR
LINE
HEAT LOAD HEAT LOAD
COOL LOAD COOL LOAD
HEAT LOAD HEAT LOAD
TWO STAGE HEAT
1 STAGE COOLING
ECO# 1-7135
REV. A