FlexiForce 9700V12 Manual De Instrucciones página 4

manual manual
5. Deleting registered cards
Press 30 - swipe card - #
Press 31 - "card number" # the card with that number is now deleted
Press 32 - 9999 - #
6. Setting the access mode
Press 40 #
Press 41 #
Press 42 #
8. Program personal access code
Press 6 "new code" # "new code" # must be a 6 digit code
Press 6 # #
9. Exiting program mode
Press *
10. Changing the card password (only needed when in card AND personal code mode)
The 9700V12/24 recognizes a different pass code for the 'card AND personal code' mode. In other words:
this code is not the same as the regular pass code.
Press * (green LED will go ON) - swipe card - "old password (default is 888888)" (red and green LED flash
alternating) "new password" # "new password" #
Green LED will be OFF and you'll hear two short (Di Di) signals to confirm. In case of failure to program
you'll hear a long (Di) signal. Try again.
11. Back to factory settings
Cut off power. Put jumper JP1 in 2-3 position. Re-connect to power. After you hear two short (Di Di) signals,
put jumper JP1 in position 1-2.
Examples of programming:
1. Change program password to 789000:
a. enter program mode by pressing #### 123456 # (green LED flashes)
b. press 0 789000 # 789000 #
c. press * (to exit program mode)
2. Add new cards in a continuous way:
a. enter program mode: #### 123456 # (green LED flashes)
Keypad/Card reader
the swiped card is now deleted
all cards are now deleted
card or personal code to access (default)
card AND personal code to access
personal code only
personal access code is deactivated
www.fl xiforce.com www.fl xiforce.com
page 3 page 3