Assembly Step; Fasten The Rail To The Motor Unit And Install The Trolley - Craftsman 139.5399211 Manual Del Propietário

ASSEMBLY STEP 2

Fasten the Rail To the Motor Unit
and Install the Trolley
NOTE: To aid in assembly and installation, replace
the foam packing around the motor unit. Remove it
after Installation Step 4.
• Working on a level surface, align the rail assembly
with the motor unit, as shown.
• Slip the coupling over the rail sprocket.
• Slide the rail through the motor unit bracket until
the coupling fits securely over the motor unit
sprocket.
• Align the two bolt holes in the rail with those in the
motor unit bracket. Insert two 1/4"-20x5/8" hex
bolts and lock nuts. Tighten securely with a 7/16"
socket wrench.
• Slide the trolley onto and along the bottom of the
rail until it snaps firmly in place. Be certain to
install it facing correctly: the trolley release
arm must be horizontal (lock position), with its
arrow pointed away from the motor unit.
Trolley
Release arm
Rail
Sprocket
Rail
Assembly
Arrow must point
toward garage door
HARDWARE SHOWN ACTUAL SIZE
Motor Unit
Bracket
Lock Nuts
1/4"-20
Coupling
Foam Packaging
10
Lock Nut
Hex Bolt 1/4"-20
1/4"-20x5/8"
Motor Unit
Sprocket
Hex Bolts
1/4"-20x5/8"