Installation; Installing The Faucet Assembly; Installing The Strainer - Glacier bay 1001362761 Manual Del Usuario

Installation

1

Installing the Faucet Assembly

□ Carefully take out all the parts of the faucet assembly (C).
The faucet is pre-assembled, except for the sprayer head.
□ Take the washer, gasket and retaining ring off of the faucet
body.
□ Place the faucet body carefully through the hole in the sink
(B). A second person may be required to hold the body in
place until the faucet installation is complete.
□ From underneath, slide the washer, gasket and retaining
ring over the end of the copper pipe and up to the exposed
threaded section of the faucet. Tighten the retaining ring by
hand until it is snug. Using a wrench or pliers, tighten the
assembly.
□ Gently tighten the two screws on the retaining ring.
Do not over tighten.
□ Screw the sprayer head onto the gooseneck pipe.
□ Connect the water supply lines (not supplied) to the faucet.
Faucet body
Gasket
Retaining ring
Screws
All manuals and user guides at all-guides.com
Gooseneck pipe
Sprayer
head
Faucet handle
Washer
Threaded section
2

Installing the Strainer

□ Apply a ring of sealant to the underside of the strainer
flange.
□ Insert the strainer body into the sink.
□ Assemble the rubber gasket, friction washer and locknut
onto the strainer body from under the sink.
□ Hand tighten the locknut. Do not over tighten the locknut as
it may split or deform the strainer body.
6
Sealant
Basket
Strainer body
Rubber gasket
Friction washer
Locknut