Swiss Peak P326.891 Manual De Instrucciones página 4

FlasHlIGHt: normal &stronG & WEaK & FlasH lIGHt
step1: Press the Power button twice continuously for normal light
step2: Press the button again for a stronger light
step3: and press the button one more time to dim the light
step4: Finally press the button again to make the torch flash rapidly, press one more time to stop flashing
maGnEt FunctIon
the pedestal of the product has a built-in magnet, so you can attach the product in a fixed place and use the
flashlight in case of emergency
P32689_Swiss_Peak_4_in_1_Speaker_Manual.indd 6-7
BluEtootH sPEaKEr
step1: Before using the speaker, please hold the power button for about 1.5 seconds, when the bluetooth is
opened, you will hear "Bluetooth mode" ;
step2: then open the bluetooth of your mobile device, search the new paired devices, you will find new device"
swiss Peak", select it to connect, you will hear" bluetooth pairing successfully";
step3: after connecting you can play music on your mobile device and listen to it through the speaker
step4: When you do not wish to listen to music it's recommended to disconnect the Bluetooth device in order
to safe battery.
noted: there are two buttons, (+) for volume down or (-) down the volume
aNNouNcEMENt
• The product is rainproof & dustproof. (IPX4).
• Do not throw the item into fire to avoid explosion.
• Do not put the charger in too hot (over 70°C), wet or corrosive environment.
• Do not put the item on vehicle's dashboard. When the dashboard temperature over 70°C, it will damage the
built-in battery and bulge out.
• This product has powerful intelligent protection function, such as overcharge, over discharge, overload, short
circuit protection function etc., effectively extending the built-in battery life and mobile phone battery life. Dual
insurance design makes the products much safety.
• If the product does not work, check one of the following options.
1). check whether the adapter is suitable for your mobile phone /electronic equipment.
2). check whether the product shuts down automatically. If yes, just activate the product by charging the
built-in battery.
3).If the charger has not been used about half a year; the power of the built-in battery will be exhausted. If the
charging indicator is weak, the charger could not charge your mobile phone.
--to solve this problem, use the provided usB cable to recharge the built-in battery for 2-3 hours, then it will
get back to work. In order to prolong the battery life time, charge it once every half a year.
• This is not a toy, please do not let children younger than 3-year-old to play with it.
6 7
23-9-2016 13:50:35