Spare Parts; Troubleshooting; Technical Specifications - FAIRLINE FHR 115 Manual De Instrucciones

Spare parts

Use only original spare parts. You will find a list
of spare parts at the end of these operating in-
structions.

Troubleshooting

You can rectify minor faults yourself with the help
of the following overview.
If in doubt, please consult the authorized customer
service.
Danger
Turn off the appliance and remove the mains
plug prior to any care and maintenance work.
Repair works may only be performed by the au-
thorized customer service.
Appliance is not running
Pull on the lever of the trigger gun; the device
will switch on.
Check whether the voltage indicated on the
type plate corresponds to the voltage of the
mains supply.
Check the mains connection cable for damages.
Pressure does not build up in the appliance
Appliance ventilation: Switch the appliance
on with the high-pressure hose detached
and operate (max. 2 minutes) until the water
exits the high-pressure connection without
bubbles. Switch off appliance and reconnect
high-pressure hose.
Check the water supply.
Pull out the sieve in the water connection us-
ing flat-nose pliers and clean under running
water.
Strong pressure fluctuations
Clean high-pressure nozzle: Remove dirt
and debris from the nozzle bore, using a
needle and rinse through with water from the
front.
Check water flow quantity.
Appliance is leaking
Slight leakage from the appliance pump is
normal. If the leakage increases contact the
authorized customer service.
No detergent infeed
Detach spray lance from the trigger gun.
Work only with the trigger gun.
Clean the detergent suction hose filter.
Check the detergent suction hose for kinks.

Technical specifications

Electrical connection
Voltage
Power consumption
Protection class
Protective class
Mains fuse (slow-blow)
Water connection
Max. feed temperature
Min. feed volume
Feed pressure
Performance data
Working pressure
Max. permissible pressure
Water flow rate
Detergent flow rate
Recoil force of trigger gun
Dimensions and weights
Length
Width
Height
Weight, ready to operate with ac-
cessories
Values determined as per EN 60335-2-79
Hand-arm vibration value
Uncertainty K
Sound pressure level L
Uncertainty K
pA
Sound power level L
WA
tainty K
WA
Subject to technical modifications!
220-240 V
1~50/60 Hz
6 A
IP X5
II
10 A
40 °C
8 I/min
0,2-1,2 MPa
8 MPa
10 MPa
5,25 I/min
0,4 I/min
10 N
366 mm
157 mm
268 mm
5,1 kg
<2,5 m/s
0,3 m/s
76 dB(A)
pA
2 dB(A)
+ Uncer- 91 dB(A)
English 7
2
2