Doberman SE-0111 Manual De Instrucciones

PACKAGE INCLUDES:
Water Detector Alert...1PC
Peel and Stick mount...1PC
AAA batteries ... 2 PCS (not included)
INSTALLATION:
Use the Peel and stick mount or the butterfly hole to attach the Water
Detector Alert on a wall in a potentially damp area of your house (Behind the
washer in the basement for example).
Extend the water sensor probe from the unit vertically down to the floor so
that it touches the floor surface.
Make sure the sensor rests on the floor surface to detect water.
BATTERY INSTALLATION/REPLACEMENT:
Unscrew and remove the battery cover.
Follow the polarity instructions, and install two AAA batteries (not included).
If installed properly, the unit will beep and flash once to indicate that it is
ready to work.
Screw the battery cover back on.
OPERATION:
Make sure the product is properly installed as per installation section above.
If the water sensor that extends down from the unit to the floor detects water,
the alarm will sound for 20 seconds. If no one attends to the water, the
alarm will go off again for 20 seconds after a 1-minute break.
This cycle will continue until the owner turns it off by pressing the "POWER"
button.
The product will reset automatically in ALARM MODE after disarming by
press the "POWER" button.
NOTES:
The unit is not considered to be weatherproof, so please do not expose the
unit to rain.
Ensure that the unit has sufficient battery power to operate as an alarm.
Check its power level periodically.
It is recommended for indoor use.
If the battery becomes weak, the LED will flash and chirp once periodically
(every 30 seconds).
Press the "POWER" button for 3 seconds, and the product will "beep"
continuously, until the button is released. This means the batteries are
properly installed.
SE-0111 WATER DETECTOR ALERT
Helps prevent expensive water damage