Calibration Mode - Peavey SANPERA I Manual Del Usuario

1 2 5 6

CALIBRATION MODE:

Occasionally it may be necessary to re-calibrate your
expression pedal. To enter CALIBRATION MODE hold
button 4 and press button 1. Upon entering CALIBRA-
TION mode the LED above button 1 will be green. This
green LED indicates that you need to press button 1 after
each step of the calibration process. Button 4 will be
RED upon entering CALIBRATION mode and allows
you to skip steps in the calibration process (normally not
necessary). During the first step of the process the lower
AUX LED will blink to prompt you to pull the pedal
back to its lowest position. With the pedal in its lowest
position, press 1 for "next." The MAIN LED will prompt
you to max the pedal to its highest position and press 1
again. Your pedal is now calibrated, turn your amplifier
3 4
off and on to complete the process.