Cable Detangler - Mongoose Netflix Stranger Things El Manual Del Propietario

3 Assembly

CABLE DETANGLER

Some BMX freestyle bicycles are equipped with a cable
detangler for the rear brake. If the upper cable is not already
assembled perform the following steps. Figure 3.20
❶ Insert the cable barrel end into the right (rear) brake lever.
❷ Adjust the brake lever adjustment barrel so that the slots
line up with the brake lever and insert the upper cable
through the brake barrel slots.
❸ Rotate the barrel so that the slots are no longer in line.
Note: One of the upper cable casings is shorter than the
other. The shorter side should be on the right. This is the
shorter distance between the brake lever and the upper
detangler plate.
❹ Thread the adjusting barrels in on both sides and hook the
cable end into the bearing unit. Note: The lower cable
should already be hooked into the lower tabs of the bearing
unit.
❺ Next try squeezing the brake lever several times to be sure
all the cables are seated in the adjustment barrels. If there is
excess play before the brake cable starts to move, this can
be adjusted by unscrewing one or more of the adjustment
barrels.
a. First adjust the barrel adjuster at the mid point of the
upper cable until the brake lever does not have any
free play.
24
b. Next squeeze the brake lever and allow it to return.
c. Check to see if the bearing unit bottoms out on the
lower detangler plate. If so, unscrew the adjustment
barrel further until the bearing unit sits about 1 mm
above the lower plate. This is the correct position for
the bearing unit.
❻ Rotate the handlebars back and forth and then turn them
completely around 360 degrees. Note if the bearing unit spins
quietly, or if it "flops" back and forth. If it has any flop, this
can be fine-tuned with the four adjustment barrels in the
upper and lower detangler plates. The goal is to reduce or
eliminate as much of the flop as possible, while keeping the
brake function consistent.
❼ Turn the handlebars 360 degrees and note whether the plate
flops forward and back, or if it flops the same way. If it flops
forward and back, adjust the upper cable barrel adjusters
until the flop is reduced. If the flop is the same way, then
adjust the lower cables until the flop is reduced. Sometimes
both need to be adjusted. The best thing to do is to adjust the
lower cables first until the bearing unit has an equal gap on
the left and right sides, then adjust the upper barrel
adjusters until the flop is minimal or none at all.
❽ Follow the brake adjustments for the type of brake the bike
is equipped with (linear pull or caliper brakes).