Basic Operation; Adaptive-Sync; Lndicator Light - Newskill ICARUS 27 Manual Del Usuario

5.Basic Operation

EN
1. Insert one end of the DP cable into your PC's graphics card. A
HDMI cable
2. Connect the power cable to your monitor then connect the other
end to your power source. It is recommended that you use a surge
protector with adequate voltage if a wall outlet cannot be reached
directly.

Adaptive-Sync

This feature is off by default. To activate, you must have hardware with Adaptive-Sync capability, a DP or HDMI cable, and the latest
graphic drivers.
After connecting your computer and monitor with a DP or HDMI cable, you may receive a prompt to enable the feature on your
computer. If you do not, you may need to enable the function in your graphics card menu. See your graphics card manufacturer's
documentation for instructions.

6. lndicator Light

Solid white light indicates power is on and the monitor is operating normally.
Flashing white light indicates no video source, no horizontal or vertical signal has been detected or voltage is low. Please ensure your
computer is on and all video cables are fully inserted and/or connected.
10
ICARUS SERIES
HDMI Connector
DP Connector
Indicator light