AbleNet Connect Guia De Inicio Rapido página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Step 1: Charge Connect
1. Assemble Connect Device Charger.
2. Plug assembled Device Charger into power outlet.
3. Insert Micro USB side of Device Charger into Connect
Charging Jack to begin charging Connect.
4. Status Light will flash red while charging. Status Light will
remain solid red when Connect is fully charged.
Connect Device Charger and Universal Adapters
Diagram 2
1-meter Apple USB
to 30-pin or USB to
Lightning Cable
Notches
All manuals and user guides at all-guides.com
Step 2: Assembly
1. Remove the black Removable Faceplate and foam insert
from Connect. See Diagram 1.
2. Plug the USB end of the 1-meter USB to 30-pin cable
or USB to Lightning cable that comes with the iPad into
the USB Jack found inside of Connect. Wind the cable
around the bottom of Connect through the notches. Small
pieces of tape can be used to help secure the cable if
needed. See Diagram 2.
3. Replace foam insert into Connect and leave the 30-pin or
Lightning connector of the USB cable hanging out. See
Diagram 3.
4. Insert iPad Air Connect Adapter Kit if you are using an
iPad Air with Connect. SeeDiagram 4.
5. Turn the iPad on.
6. Connect the 30-pin or Lightning connector to the iPad
and insert the iPad inside of Connect. Replace the black
Removable Connect Faceplate.
Diagram 3
USB Jack
Diagram 1
Diagram 4
Attach iPad Air Adapter Kit
Bumpers Here

Publicidad

Tabla de contenido
loading

Tabla de contenido