Troubleshooting - Viatek LIFE JUICER Manual De Instrucciones

9. TROUBLESHOOTING

PROBLEM
Machine does not operate
Machine jams / clogs or stops
operating
Squeaking noise when juicing
Leaking from underneath the
bowl
Strainer Damage
Too much pulp coming out
Bowl is stuck and will not
detach from the base
Food Chute / Lid is stuck
Color stain on the bowl,
strainer, spinning brush
Water mark or scratch on the
Auger
All manuals and user guides at all-guides.com
• Check the power cord and power source.
• Ensure that all parts have been assembled correctly.
• Ensure the food chute is clear and not blocked.
• Ensure that hard seeds have been removed before
juicing and are not stuck in the machine.
• Turn the machine off and switch to reverse for 3
seconds.
• Disassemble the upper section and clear any
remaining pulp.
• The squeaking sound is perfectly normal. Do not run
the juicer without any food.
• Be sure the silicone pad is tightly in place after
cleaning.
• Refer to the operating instructions for proper usage
and juicing tips. Remember not to overstuff food or
force food into the juicer.
• Cut food into smaller pieces, especially fi brous foods,
to avoid fi bers scraping around the Auger. Insert food
at a slower pace and allow all food pulp to eject the
unit before adding more.
• This is commonly caused by excess food in the bowl.
Press the reverse button for 3 to 5 seconds. Repeat
the process 2or 3 times. Then, push the bowl upward
while turning.
• Press the reverse button for 3 to 5 seconds. Repeat
the process 2 or 3 times. You can then press down on
top of the lid while turning.
• Natural dye from food when juicing is perfectly nor-
mal. To reduce staining, rinse and clean immediately
after each use. Diluted vinegar or bleach can also be
used.
• Molding marks during the manufacturing process.
These marks and lines on the squeezing screw are
perfectly normal.
·10·
SOLUTION