Publicidad
TxConfig-DIN43650 and TxConfig-M12
Interface
Quick Guide
The TxConfig-DIN and TxConfig-M12 are the configuration interfaces
for the transmitters with DIN and M12 connectors. The configuration
interface supplies power for the transmitter during the configuration
process and works with the TxConfig II configuration software.
FEATURES
Easy to install, no special driver needed;
•
USB communication to the PC and serial to the transmitter;
•
Configures the transmitter without an external power supply,
•
powered by the USB bus;
Electrical connections made easy;
•
Compatible with USB 1.1, 2.0 and 3.0;
•
Operating system: Windows 8, 7, Vista or XP.
•
ELECTRICAL INSTALLATION
Connect the interface to the transmitter as shown in Fig. 1
•
(DIN43650) and Fig.2 (M12);
Connect the configuration interface to a USB port on the PC;
•
Does not require external drivers installation;
•
Launch the previously installed TxConfig II software in order to
•
perform the transmitter configuration.
OPERATION
Follow the instructions from the TxConfig II software.
Status Led:
- Led on: means the interface was installed and is ready to be used.
- Led blinking: means the configuration data is being sent.
Warning: The USB interface is not electrically
isolated from the transmitter input. Take the proper
care when configuring field installed transmitters to
avoid ground loops.
ELECTRICAL CONNECTIONS
English
Fig. 1 – TxConfig-DIN43650 electrical connections
Fig. 2 – TxConfig-M12 electrical connections
T x C o n f i g - D I N 4 3 6 5 0
a n d T x C o n f i g - M 1 2
I n t e r f a c e
Q U I C K
G U I D E
WARRANTY
Warranty conditions are available on our web site www.novusautomation.com.
Man 5010048 V1.0x
Publicidad
