STACK-ON PDS-1800-B Manual De Instrucciones

PDS-1800-B
Serial #:
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Keep keys in a secure place away from children.
DO NOT STORE KEYS INSIDE SAFE
Battery Disposal
Please dispose the used batteries
per municipal or provincial law.
HARDWARE INCLUDED:
(2) M6 x 15 mm (5/8" long) Screws
(2) M6 Nylock Nuts
TOOLS REQUIRED:
Drill
Flat Head Screwdriver
Thin Bladed Flat Head Screwdriver
10 mm Wrench
1/4" (7 mm) Drill Bit
®
When you first receive your safe you will
need to open the door with the key in order
Instructions
to install the batteries. Batteries are included
and are located inside the safe.
To open the door with the key, first remove
the lock cover from the front of the faceplate
using a thin bladed flathead screwdriver as
shown. Insert the key and turn
counterclockwise. Hold the key in the open
position and turn the knob to the right to
open the door.
NOTE: With door open, turn the knob to the left
then turn the key back to the locked position to
remove the key.
NOTE: This key has also been provided in case
the batteries run low. If you lose your key, you
may purchase a replacement key by referencing
the serial number located under the removable
lock cover plate. See section at the end of this
instruction regarding replacement keys.
Locate the batteries inside the safe. Open the
battery compartment on the back of the door
by pushing the tab in the direction of the arrow
and install the batteries.
NOTE: The reset button located on the inside
of the door, is covered with a removable cap.
When you use the reset button while recording
your fingerprint, remove the cap to access the
button. Use a pen tip to push the reset button.
Replace the cap securely over the reset button
after recording your fingerprint. Failure to do
so will compromise the safety and security
of the safe.
GETTING STARTED
KNOB
LOCK COVER
40792-1805
1
12