V-TAC VT-5156 Instrucciones De Instalación página 9

ENGLISH
D. AP DIRECT MODE (SPECIAL)
• Open the YCC365 plus APP to enter the login interface. Tap on "Local direct connection" as
shown in Figure 22[A]
• Tap on plus sign on the top right hand corner as shown in Figure 22[B].
• Power up the camera and wait until you hear the voice "Please configure camera by AP
hotspot or scanning code" and Tap on "Next" as shown in Figure 22[C] (if you don't hear the
voice, reset the camera）
• Tap on "Go to setting" as shown in Figure 22[D] and connect the camera hotspot named
with "CLOUDCAM_XXXX" as shown in Figure 22[E]. After connecting the camera go back to
the APP and tap on "Next" as shown in Figure 22[F]. If unsure please refer to Figure 22[D]
and tap on "How to connect the device".
• Enter the User name: admin | Password: 12345 and tap on "Next", as shown in Figure
22[G].
• On app it will also show "Addition is successful"- Select/type the device name (Figure
22[H]) and tap on "Start to experience"
FIGURE 22 [A] FIGURE 22 [B] FIGURE 22 [C]
FIGURE 22 [D]
FIGURE 22 [E] FIGURE 22 [F] FIGURE 22 [G] FIGURE 22 [H]