Horizon Global 76432 Instrucciones De Instalación página 4

1.) Remove the Fascia
a.) Using an 8mm socket, remove (1) screw from the lower rear side of the wheel well, both sides.
b.) Using a drill and a 3/16" drill bit, remove (2) rivets (for Durango) or (4) rivets (for Grand Cherokee) above the screw previously removed on each side of the vehicle.
c.) Using a 10 mm socket, remove the uppermost screw on each side of the vehicle and two bolts located near the spare tire holding the fascia to the bumper beam
d.) Pull the wheel well cover slightly outward. Once moved, use a 7mm socket to remove (1) screw located under the cover from each side of the vehicle.
e.) Using a T30 torx bit, remove (2) screws located near the brake lights, underneath the fifth door.
f.) (Durango only) Remove the fascia and trim according to Figure 2. Note: be sure to keep the lower part of the fascia connected, only trim along the red line.
A
C
E
©2021 Horizon Global Americas Inc. - Printed in Mexico
B
D
F
C
B (Jeep)
Sheet 4 of 18 76432NP 1-11-21 Rev. A