Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
page 2
IMPORTANT:
Provide each unit with a DC power supply from a 5 V through 30V un-switched circuit used for emergency
lighting.
Junction box mounting:
1
-Some details shown below may vary-
A. Use code-approved connectors to connect input leads inside
J-box [See label on wire pair for positive and negative
polarity colors].
B. On the mounting plate, open the desired keyhole junction-
box knockouts.
C. Route input connector through center hole in mounting plate.
D. Taking care not to pinch wires or connectors dressed inside
junction box, secure mounting plate to junction box screws.
NOTE: to ensure proper engagement of the mounting plate
latches to the housing, DO NOT OVER-TIGHTEN THE
SCREWS.
Housing attachment to mounting plate:
2
A. Plug the input connector to the receptacle on the lamp
driver board.
B. Ensure that wires are routed to avoid interference with
other components, and push housing straight onto mounting
plate, making certain both latches are fully engaged.
Wiring diagram
Twin Driver Board
DC input to the remote
units. See label on wire
pair for positive and
negative polarity colors
INSTALLATION and WIRING
Remote Lamp
Remote Lamp
LIFE SAFETY SOLUTIONS
TEL: 800-334-8694
Push housing straight onto mounting plate
Single Driver Board
DC input to the remote
units. See label on wire
pair for positive and
negative polarity colors
www.lithonia.com
Junction boxes accommodated:
4" Square
4" Octagon
3-1/2" Round or Octagon
Single Gang Box
Remote Lamp
Part # 912-00028-001
Rev. A, 10/2018
© Acuity Brands Lighting, Inc. 2018
All Rights Reserved.
Publicidad
Tabla de contenido
