Parts List - EDSAL MUSCLERACK UR361872PB5G Manual De Instrucciones

Parts List

A
Preparation
Assembly of this unit is done by fitting the two rivets of the braces (B) and beams (C) into the keyhole slots of the post (A). The narrow end
of the keyhole slots from the post must face down (see FIG.1). Braces and beams must be installed with the ledge facing up on the inside.
Assemble the unit from bottom to top. It is recommended that the bottom shelf assembly be installed into the second keyhole slots at the
bottom of the posts. The middle shelves should be evenly spaced. A rubber mallet should be used to tap down on the top of the braces and
beams to properly seat the rivets down into the narrow end of the keyhole slots (see FIG. 2 and FIG. 3).
FIG. 1
A
Narrow end
of slots face
down
B & C
ALTERNATE ASSEMBLY
This unit can also be assembled as two separate 36 in. high units (see FIG. 4). One unit
will have three shelves and the other will have two shelves. If choosing this option, follow
assembly steps 2, 3, 4, 5 and 9 until all shelf levels are completed for both units. Note: Use
all 8 of Post Caps (F) in final step 9. Post Reinforcements (E) are not used for this setup.
HELPFUL TOOLS/ITEMS FOR ASSEMBLY (NOT INCLUDED):
Rubber Mallet
B
C
D
FIG. 2
Rivets
Use a rubber mallet
to lightly tap down
on Brace / Beam to
seat the rivets down
into the narrow end
of the post slots.
Gloves
Parts List: Model UR361872PB5G/ Item 889201
36"W x 18"D x 72" (91cm x 45cm x 182cm)
Description
A. Post
E
B. Brace
C. Beam
D. Particleboard Deck
E. Post Reinforcement
F. Post Cap
Parts List: Model UR482472PB5G/ Item 889202
F
48"W x 24"D x 72"H (121cm x 60cm x 182cm)
Description
A. Post
B. Brace
C. Beam
D. Particleboard Deck
E. Post Reinforcement
F. Post Cap
FIG. 3
Rivets properly
seated into the
narrow end of
post slots.
FIG. 4
Qty Part#
8 URPS36-GRY
10 URBR18-GRY
10 URBM36-GRY
5 RPB31836
4 CPIN-GRY
8 RL-PC-B1
Qty Part#
8 URPS36-GRY
10 URBR24-GRY
10 URBM48-GRY
5 RPB32448
4 CPIN-GRY
8 RL-PC-B1
✓
Alternate Assembly:
Two 36 in. high units.
E