fourstargroup 11222775B Instrucciones De Montaje

MODEL: 11222775B
COMPUTER DESK
STEP 1
INSERT DOWEL (3) TO PANEL (D) WITH GLUE (7).
3x2pcs
7
D
STEP 5
5.1 ATTACH PANEL (E) TO PANEL (C) (D) TIGHTEN WITH SCREW (2).
5.2 INSTALL NAIL LEG (4) TO BOTTOM SIDE OF PANEL (B) (C) (D) BY
USING HAMMER.
4x6pcs
F
B
E
E
G
C E
A
D
2x12pcs
CAUTION :
1. ADULT SUPERVISION IS REQUIRED DUE TO SMALL PARTS.
CARE SHOULD BE TAKEN IN THE UNPACKING AND
ASSEMBLY OF THE PRODUCT.
2. ASSEMBLE ON SOFT SURFACES TO PREVENT DAMAGE TO
THE PRODUCT FINISH.
3. MAKE SURE ALL PARTS ARE INCLUDED BEFORE ASSEMBLY.
BEFORE YOU BEGIN, PLEASE READ ASSEMBLY INSTRUCTIONS
CAREFULLY. FOLLOW THEM STEP BY STEP.
ASSEMBLY TOOLS REQUIRED
MALLET
PHILIPS SCREWDRIVER
Do you have any questions? Missing small parts or hardware? If you need
assistance with the assembly of your COMPUTER DESK please e-mail our
support@fourstari.com or
Customer Service Department at:
call us at (800) 639-3803 or (508) 473-7688
if calling locally
from Massachusetts area
Please include the following information in your email:
• Where item was purchased • Item, model, style or SKU number listed on
instructions or box • Part number, description of the part and quantity needed
This information will help us get the proper part to you faster
STEP 2
FACE DOWN TOP PANEL (A) ON THE SMOOTH SURFACE TO
PREVENT SCRATCHES, ATTACH PANEL (D) TO IT WITH GLUE (7).
D
A
7
UNFINISHED SURFACE
STEP 6
FASTEN BACK PANEL (H) TO BACK POSITION OF PANEL (E) WITH
POWER PIN (8).
H
B
8x3pcs
E
F
C
G
A
PARTS LIST AND HARD WARE
NO HARDWARE LIST
1 CHIPBOARD SCREW M4X38
Y.
2
CHIPBOARD SCREW M3.5X32
3
WOODEN DOWEL
4 NAIL LEG
NON WOOVEN BIN
5
6 SCREW COVER STICKER
WHITE GLUE
7
POWER PIN
8
STEP 3
ATTACH PANEL (B) (C) TO PANEL (A) TIGHTEN WITH SCREW (1).
B
D
C
A
1x4pcs
STEP 7
7.1 UPRIGHT THE DESK.
UNFOLD THE BIN (5) AND PUT INTO THE STORAGE.
7.2 COVER THE SCREW POSITION WITH STICKER (6).
6x24pcs
5
QTY NO PARTS LIST
A
4PCS TOP PANEL
B LEFT SIDE PANEL
22PCS
C RIGHT SIDE PANEL
2PCS
6PCS D
CENTER PANEL
3PCS E
SHELF PANEL
1SET F
BOTTOM CROSSBAR
1PC
G
TOP CENTER SUPPORT
3PCS H
BACK PANEL
STEP 4
ATTACH PANEL (F) (G) TO PANEL (B) (C) TIGHTEN WITH SCREW (2).
F
B
C
D G
A
2x10pcs
This unit is intended for use only with the products and maximum weights
indicated. Use with other products or products heavier than the maximum
weights indicated may result in instability causing possible injury.
Furniture can tip over or break if improperly moved. Have a friend help
to lift and carry the unit to it's new location.
QTY
1PC
1PC
1PC
1PC
3PCS
1PC
1PC
1PC