Homewerks Worldwide Home2O 2F168BLCH Manual De Instrucciones

TWO FUNCTION RAIN CAN SHOWERHEAD
WITH MULTI-COLOR TEMP LED AND
SMARTWAVE TECHNOLOGY
2F168BLCH – Polished chrome finish
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
A Showerhead
B PTFE tape
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list and hardware contents. If any part is missing or
damaged, do not attempt to assemble the product. Contact customer service
for replacement parts at (877) 319-3757, 8 a.m. - 5 p.m., CST, Monday - Friday.
Estimated Assembly Time: 15 minutes
Tools Required for Assembly (not included): Adjustable Wrench
BUILT-IN HYDRO-GENERATOR – PROPER OPERATION
This showerhead is designed to operate under water pressure of 20 - 80 PSI.
Water pressure lower than 20 PSI will not generate enough power to run the
built-in hydro-generator system. Water pressure higher than 80 PSI may damage
internal components.
COLOR TEMP LED
Color of LED light changes automatically according to water temperature:
BLUE: Cool under 81ºF (27ºC)
GREEN: Warm 81-106ºF (27-41ºC)
RED: Hot above 106ºF (41ºC)
NOTE: When water temperature stays at 81ºF (27ºC) and 106ºF (41ºC),
LED color may change between two colors.
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • www.homewerksww.com
QUANTITY
A
1
1
Installations may vary depending on how the previous showerhead was installed.
Supplies necessary for the installation of the showerhead are not all included;
however, they are available wherever plumbing supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn
on the old faucet to release built-up pressure. When installing the new faucet,
hand tighten the connector nuts. DO NOT OVERTIGHTEN. Connections
that are too tight will reduce the integrity of the system.
WARNING
Do not remove the flow restrictor. Operating without the flow restrictor will
cause the electrical components to fail.
B
LED
09-05-2018