Conairphone SW9280 Guia De Inicio Rapido página 2

IMPORTANT NOTICE
TM
Your CONAIRPHONE will operate on either true tone or
rotary systems.
1. If your home is wired for rotary service, move the
Tone/Pulse switch to Pulse position (P).
2. If your home is wired for Tone service, move the
switch to the Tone position (T).
3. If you are unsure which type of service you have,
position Tone/Pulse switch to Tone (T). If dialing can
not be done, set to Pulse (P).
INSTALLATION
Line Cord Connection
With modular jack telephone system connect the
straight telephone line cord to the modular jack located
at the back of the base. Insert the other end of cord into
a modular wall jack. Make sure all plugs snap firmly in
place (see Diagram B).
With a four prong style jack, simply use a plug in
modular adapter (see Diagram C).
Earset Cord Connection
Insert the earset plug (A)
into the jack on the unit (B)
(see Diagram D).
4
All manuals and user guides at all-guides.com
EARSET
The earset can be used on either the left
or right ear. Adjust the swivel cap (B) so
that the earset is compatible to either
the right or left ear. For an ideal fit on
virtually any ear, the SW9280 comes with
two different sized receiver brackets.
The larger receiver bracket is already
installed on the earset. To use the smaller receiver
bracket, twist off the larger receiver bracket by turning
counterclockwise. Replace with the smaller receiver
bracket by turning clockwise. Rotate the microphone
boom (A) so that the microphone cap (C) is pointed
towards the mouth. For servicing or replacement, please
contact us for a suitable earset.
Receiving a Phone Call
1. When your phone rings, slide the On/Off switch to the
On position. The On/Off switch LED turns On.
2. To disconnect the line, slide the On/Off switch to the
Off position. The On/Off switch LED turns Off.
Diagram B
Dialing a Call
NOTE: Before dialing, make sure the Tone/Pulse switch
is correctly positioned for your type of service. Your
TM
Conairphone (in pulse setting) uses electronic pulses
Diagram C
to simulate dialing. You might hear pulsing for a second
or two after the last button has been pressed.
KEY FEATURES
The SW9280 includes an earset cord clip for added
convenience!
To use the earset cord
clip, put on the earset.
Slide the clip onto clothing
with the cord holder facing
out. Place the cord over
Diagram D the holder and press
down to secure.
BELT CLIP
Convenient belt clip for mobility and comfort.
LAST NUMBER REDIAL
Your CONAIRPHONE
dialed. If the number you dial is busy or not being
answered, hang up. To automatically redial the last
number, press the REDIAL button.
NOTE: You can redial the same number as many times
as needed. However, once you dial another number, the
previous number is erased.
FLASH
The FLASH key can be used to retrieve a new dial tone
after ending a call.
NOTE: The FLASH button is also a useful feature for
special telephone service such as call waiting and three
party calling. Press briefly, release, and perform the
custom call procedure. After you have used the FLASH
function, and you wish to use the REDIAL function, you
must reset the unit before the redial function can be
used. Reset the telephone by turning the On/Off switch
to the Off position and then to the On position.
RECEIVER VOLUME CONTROL
The Receiver Volume Control is located on the side of
the phone. This control allows you to adjust your
receiver volume from normal to high for a more
comfortable listening level.
5
TM
remembers the last number
6