Thank you for purchasing this Texsport hammock. Please read and understand each step of the set-up instructions. Hammock hanging configurations will
vary depending upon the location you choose to set-up your Wilderness Hammock. 30 Feet of utility cord and/or tent stakes will be needed to complete
set-up. We hope you enjoy your new hammock and that it will give you many years of outdoor pleasure.
CAUTION: DO NOT JUMP UP AND DOWN ON THE HAMMOCK. DO NOT USE IT AS A PLAYGROUND SWING.
CHILDREN HAVE BEEN KNOWN TO USE HAMMOCKS AS A TRAMPOLINE OR TRY TO SWING OFF OF THE
HOOKS. THIS IS DANGEROUS AND NOT THE INTENDED USE OF YOUR HAMMOCK. IT ALSO WILL CAUSE EXCES-
SIVE WEAR AND TEAR ON THE HAMMOCK AND MOUNTING HARDWARE.
THE MAXIMUM SAFE WEIGHT LIMIT FOR THIS HAMMOCK IS 250 LBS. PLEASE NOTE AND OBSERVE THIS LIMIT.
MAINTENANCE:
By observing the following suggestions, your hammock will provide many hours of relaxing pleasure:
• Store your hammock in a cool, dry place. Be certain that it is not wet or damp when rolled and stored or the rope may mildew
or rot. If he hammock does get wet, let it dry completely before storing.
• Although this hammock is intended for outdoor use, exposure to adverse weather conditions such as UV rays, rain or snow
alter the appearance and decrease the life span of the hammock. Therefore, please handle your hammock with care in order to
obtain maximum enjoyment.
• Do not hang or store your hammock in an area where wildlife may potentially have access. Avoid storing near chemicals and
pesticides which, if spilled, may effect the strength or integrity of the fibers used in this hammock.
• Handwash using a mild detergent. Rinse well. Hang to dry. Allow it to dry completely before using or storing. Do not use any
products with bleach or strong chemicals.
SET-UP AS A TENT:
Step 1. Spread out material.
Step 4 Locate web straps on top part
of material. Tie ropes (not included)
through elastic loops. Three on each
end.
ASSEMBLY INSTRUCTIONS
#14242 • Wilderness Hammock
Note: 30 ft. of utility cord and/or tent stakes will be needed (not included)
Step 2. Insert stakes (not included)
through web straps on four corners.
Step 5 Tie opposite ends of ropes to
trees or other secured overhang.
Step 3. Spread out top portion of ma-
terial.
Step 6 This is how your hammock/
tent should look.