Descargar Imprimir esta página

JENN-AIR JXA9003CDP Guia De Inicio Rapido página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
Note: This backsplash must be installed before the hood shell. The hood shell covers the mounting
screws at the top of the backsplash.
1. Mark a level line on the wall at 16" below bottom of hood location.
2. Position the lower section of backsplash (flat part with flange at top) on the wall. Center it side to
side and mark the top and bottom holes. Remove the lower section from the drywall.
3. Insert wall anchors into the marked holes. (We recommend drywall E-Z anchors)
4. Attach lower section of backsplash to wall with screws provided.
5. Position upper section of backsplash by engaging its flange with the lower section. Push up to
fully engage flanges, center it side to side, and mark the location of the mounting holes. Remove
the upper section from the drywall.
6. Insert wall anchors into the marked holes. (We recommend drywall E-Z anchors)
7. Insert the retaining clips and hinge clips to the upper section. The retaining clips go in the top
two openings and the hinge clips go in the bottom four openings. Fasten and tighten the clips to
the back of the upper section with the nuts provided.
8. Attach upper section to wall with screws provided.
INSTALLATION
2

Publicidad

loading

Este manual también es adecuado para:

Jxa9002cdpJxa9001cdp