Barrette EPN-51293 Manual De Instrucciones página 5

8.
Using a torque wrench, begin to tighten hex head
bolt. As you tighten you will hear the collet pop. This
is the collet separating apart as it is designed to
wedge out toward the corners of the post to secure it
in place. Continue to tighten to 50-60 foot pounds of
force (Fig. 11).
9.
Anchor surface mount assembly with installed post
to the desired position on the job using the 4 anchor
holes located in each corner (Fig. 12).
10.
Install decorative cover using molded attachment
plugs (Fig. 13).
Fig. 11
Fig. 12
Fig. 13
5